Noble Fates exhaust pipes
Bronze exhaust pipes move smoke through a tight wall without the heat loss of a hole. Drag segments from the stove or hearth until an outdoor tile. One open end indoors is the intake. A run that never reaches outside is dead. Applies from before 1.0, still relevant after the 1.0 vent fix.
| Fact | Detail | Status |
|---|---|---|
| Research | Bronze Exhaust Pipes, temperature tree | 1 source · see Sources |
| Path | From stove or hearth, through a wall, to outdoors | 1 source · see Sources |
| Intake | One open indoor end | 1 source · see Sources |
| Failure | If the run never goes outside, it does not work | 1 source · see Sources |
| 1.0 | Wall and roof vents no longer dump smoke into terrain | 1 source · 1.0 news |
The pipe is a path, not a sticker on the stove
Two Steam threads, one of them with a developer in the replies, describe the failure mode better than any menu. You research Bronze Exhaust Pipes, then you drag segments. The run starts at the stove or the hearth and has to end on a tile that is outdoors. An open end left inside the room is the intake, which is the opposite of how a cosmetic chimney works. If every end is buried in the wall, you built a closed loop and the room still fills with smoke.
I do not have a copper-per-segment price. The localization says bronze or copper and a wall segment. Counts are absent. Heat range in tiles is also absent. The heating page already refused a two-tile rumor. This page refuses it again, for a different part.
Vents got a fix. Pipes did not become obsolete.
1.0 stopped wall and roof vents from pushing smoke into solid ground, and doors stopped blocking smoke. That makes a short vent more reliable than it was. It does not delete the reason pipes exist. A vent wants a straight shot. A pipe turns. Kitchens tucked under a stair still need the turning piece. Temperature is the other half. The threads say the pipe avoids the heat loss of an open hole. I am not quoting a degree figure. They did not give one.
Coolers are the rival machine in the same room. A Frostcap cooler wants the room cold. A pipe wants the fire’s smoke gone while the heat stays. Point them at different problems. If the stove error is “unused heat source,” you need another fire, not another pipe. The pipe does not create heat. It only carries smoke.
Questions people actually ask
Why is the pipe doing nothing?
The run does not reach an outdoor tile, or you left no indoor intake.
Where is the research?
Bronze Exhaust Pipes, on the temperature tree.
Did 1.0 replace pipes with vents?
No. Vents were fixed. Pipes remain the turning option.
Related pages
Sources
- Steam: how to make exhaust pipes work — checked 2026-11-15
- Steam: exhaust pipes to heat — checked 2026-11-15
- 1.0 news — checked 2026-11-15